[Back to Index] |
|
Full set the system |
1. |
Press [1] |
|
2. |
Press [ENT] |
|
3. |
Enter [User code] |
Exit tone sounds |
Part set the system |
1. |
Press [2] |
|
2. |
Press [ENT] |
|
3. |
Enter [User code] |
Exit tone sounds |
Unset the system |
1. |
Enter [User code] |
Entry tone stops |
Reset system after alarm condition |
1. |
Enter [User code] |
|
Omit a zone |
1. |
As full or part set plus |
Exit tone sounds |
2. |
Press [OMIT] |
|
3. |
Press [Zone number to omit] |
Zone is omitted |
4. |
Repeat above two steps as required for addition zones |
|
Change your own user code |
1. |
Press [4] |
|
2. |
Enter existing [User code] |
|
3. |
Enter existing [User code] again |
Two beeps sound |
4. |
Enter new [User code] |
Two beeps sound |
Test the alarm sounders |
1. |
Press [8] |
|
2. |
Press [ENT] |
|
3. |
Enter [User code] |
Sounders should sound |
Walk test the detection devices |
1. |
Press [9] |
|
2. |
Press [ENT] |
|
3. |
Enter [User code] |
Walk test detectors as required - sounder tone changes to indicate detector active |
4. |
Press [ENT] to end test |
|
View the event log |
1. |
Press [5] |
|
2. |
Press [ENT] |
|
3. |
Enter [User code] |
|
4. |
Press [1] for earlier events and [3] for later event |
|
|
|
[Back to Index] |