Scantronic 9200 family User Instructions

[Back to Index]
 
Full set the system
1. Enter [User code] Exit tone sounds
Part set the system
1. See omit zone
Unset the system
1. Enter [User code] Entry tone stops
Reset system after alarm condition
1. Enter [User code]
Omit a zone
1. Enter [User code]
2. Press [OMIT2] Zone 2 is omitted
3. Press [ENT]
Change your own user code
1. Press [6]
2. Press [ENT]
3. Enter existing [User code]
4. Enter new [User code]
5. Press [ENT]
Test the alarm sounders
1. Press [4]
2. Press [ENT]
3. Enter [User code] Sounders should sound
Walk test the detection devices
1. Press [5]
2. Press [ENT]
3. Enter [User code] Walk test detectors as required - sounder tone changes to indicate detector active
4. Enter [User code] to end tes
 
  [Back to Index]