| [Back to Index] | ||
| Full set the system | ||
| 1. | Enter [User code] | Exit tone sounds |
|---|---|---|
| Part set the system | ||
| 1. | Press [1] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | Exit tone sounds |
| Unset the system | ||
| 1. | Enter [User code] | Entry tone stops |
| Reset system after alarm condition | ||
| 1. | Enter [User code] | |
| Omit a zone | ||
| 1. | Enter [User code] | |
| 2. | Press [OMIT] | |
| 3. | Press [Zone number to omit] | |
| 4. | Press [ENT] | Zone is omitted |
| 5. | Repeat above three steps as required | |
| Change your own user code | ||
| 1. | Not possible | Changing the user code is an engineer only feature! |
| Test the alarm sounders | ||
| 1. | Press [4] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | Sounders should sound |
| Walk test the detection devices | ||
| 1. | Press [5] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | Walk test detectors as required - sounder tone changes to indicate detector active |
| 4. | Repeat above to end tes | |
| [Back to Index] | ||